Mitsubishi Electric DX-PC for View User Manual page 16

User's Manual
The Map panel pops up another screen when alarm-in, motion
or video loss events are detected or when you click the device
icon according to the Map Editor settings. Change the popup
screen location by clicking the left mouse button on the screen
and dragging it to where you want it located. Clicking the
right mouse button on the popup screen displays the following
popup menu.
 x0.25 to x2: Sets the desired size of the Map popup screen.
 Full Screen: Enters the full-screen mode of the Map popup screen.
 Transparency...: Adjusts the transparency of the popup screen.
 PTZ Set...: Controls pan, tilt and zoom of the selected PTZ camera.
 Disable Time Out: Continues displaying the popup screen when events are detected by
disabling the dwell time out.
 Original Ratio: Displays the Map popup screen by matching its original aspect ratio.
 Anti-Aliasing Screen: Enhances image display quality on the popup screen by smoothing
stair stepping (aliasing) effects in the enlarged image.
 User Set...: Sets the mode of the current popup screens displayed on the monitor. For
example, the monitor displays the current popup screen with enough frames for 16 cameras
when you select 4x4.
NOTE: Refer to Appendix C – Map Editor, Device Setting section for more details about the popup
function.
To connect to the remote site, select the device you want to connect to from the Map panel and then drag
and drop it in the desired position on the screen or the Status View panel. Also, placing the mouse cursor
on the device on the map displays the device status. When the device detects any event or the device is not
working properly, the following status icons appear (maximum of 4).
Unplugged
Video Blind
Alarm In
NOTE: The device status is displayed as Irregular based on to the system check settings and as
each event according to the event detection settings on the remote DVR.
NOTE: Some status icons may not be supported, depending on the specifications and version of the
remote DVR.
Clicking the right mouse button on the Map panel causes a text menu screen to display. Selecting Watch
Event View from the menu displays the event information of the connected remote sites. Selecting Close
disconnects the current connection on the Map panel.
12
Event Off
Motion
Alarm Out
Irregular
Object Detection
Video Analytics Detection
Video Loss
Audio Detection