Burning System - Waveshare E9 User Manual

Waveshare Electronics
Address: Rm 813, Dynamic World Building, Zhenhua Rd, Futian District, Shenzhen, China
TEL: +86-755-83040832 Web: http://www.wvshare.com/
FAX: 86-755-83042572 E-mail: sales@wvshare.com
#### User Application end #####
Corresponding burning file should be:

9.3.3 Burning System

J8 is the E9 mini PC BOOT mode selection interface. Shorting different jumper cap will have different boot
modes. It is 2.00mm pitch and 10Pin interface and it needs to work with 2.00mm pitch jumper cap.
As it is used SD card to burn, then it needs to boot via SD card. Please short the pin 1 and pin 7 with jumper cap
and put the tf card to the TF slot, long press the power button, then the system boots. Then the system burning will
automatically finished according to the EmbedSky.ini contents.
(The whole process may take about 5 minutes, which will be different from computer to computer, please be
patient!)
When the burning is complete, the power indicator will be off automatically.
Note: After done, users need to reset the default boot mode (The default system is android) in the uboot config
(see the tips in the chapter 4.4), then it can boot the system normally.
66