Ubuntu Tools Installation And Configuration (Minicom); Install Minicom; Config Minicom - Waveshare E9 User Manual

Address: Rm 813, Dynamic World Building, Zhenhua Rd, Futian District, Shenzhen, China
As all the steps are finished, then Android development environment has been installed.

3.2 Ubuntu Tools Installation and configuration (minicom)

3.2.1 Install minicom

Usrs can install the minicom via network or using the Source Code contained in the CD directly.

Network Installation: It needs to connect the internet, easy and suggested.
Directly input the command in the terminal:
 Source Code Installation:
Minicom installation source code is in the "Software\Linux tools" directory.
Copy the minicom-2.5.tar.gz to PC Ubuntu system /opt/EmbedSky/ directory, and then extract it to PC
Ubuntu, carry out the command
minicom-2.5.tar.gz -C /opt/EmbedSky
/opt/EmbedSky/minicom-2.5
Enter the following commands in sequence to start the installation:
#./configure configure source code
#make compile source code
#make install install minicom

3.2.2 Config minicom

After install the minicom, input the command
the up and down key on the PC keyboard to choose serial port setup, then press Enter to enter a serial port
configuration:
Waveshare Electronics
TEL: +86-755-83040832
FAX: 86-755-83042572
#apt-get install minicom
#cd /opt/EmbedSky/, and then use the unpack command:
to /opt/EmbedSky
to the source code directly unpacked just now.
#minicom –s
Web: http://www.wvshare.com/
E-mail: sales@wvshare.com
directory, carry out the command
to start, then there will be a configuration list: Using
19
#tar zxf
#cd