Miter Gauge Adjustments - Grizzly G0690 Owner's Manual

Miter Gauge
Adjustments
The miter gauge can be adjusted so it is perpen-
dicular to the blade and snug in the T-slot.
Tools Needed
90° Square ........................................................ 1
45° Square ........................................................ 1
Hex Wrench 2.5mm ........................................... 1
Hex Wrench 2mm .............................................. 1
Hex Wrench 3mm .............................................. 1
Checking/Setting 90° Stops
1.
DISCONNECT THE SAW FROM POWER!
2.
Slide the miter gauge into the T-slot on the
table.
3.
Loosen the miter gauge lock knob, pull out
the positive stop knob, then pivot the miter
gauge body to 90° so the stop knob springs
into position.
4.
Place the square evenly against the face of
the miter gauge and the blade, as shown in
Figure 122.
Blade
Square
Miter Gauge
Figure 122. Checking 90° stop on miter gauge.
— If the square touches the miter body and
the body of the blade (not the teeth) evenly
at the same time, then it is square to the
blade and the 90° stop is set correctly. No
further adjustments are necessary.
-72-
— If the square does not touch the miter body
and blade body evenly at the same time,
then proceed to Step 5.
5. Loosen the button head cap screws on the
positive stop knob block (see Figure 123),
adjust the miter body until it is flush with the
square, then tighten the screws.
Qty
Figure 123. Screws for adjusting miter gauge
6. Loosen the screw on the front of the miter
bar, adjust the pointer to 0°, then tighten the
screw.
Adjusting Miter Bar Tightness
The miter bar can be adjusted so it fits more
tightly in the miter slot.
To adjust the miter bar tightness:
1. Loosen the cap screw on each guide block
(Figure 124), adjust the set screws as need-
ed, then tighten the cap screw.
Cap Screws
Figure 124. Screws for adjusting miter bar in
Positive
Stop Knob
Button Head
Cap Screws
body.
Set Screws
Guide
Block
miter slot.
Model G0690/G0691 (Mfd. 6/15+)