Installation; Fitting The Wall Spacer - NEFF K58 series Instructions For Use Manual

en
ã=
Warning
Never connect the appliance
to electronic energy saver plugs.
Our appliances can be used with mains
and sine-controlled inverters. Mains-
controlled inverters are used
for photovoltaic systems which
are connected directly to the national
grid. Sine-controlled inverters must be
used for isolated applications (e.g. on
ships or in mountain lodges) which are
not connected directly to the national
grid.

Installation

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe
the following minimum distances to a
heat source:
3 cm to an electric cooker.
■
30 cm to an oil or coal-fired cooker.
■
Appliances with fitted handles
must be situated at least 55 mm
from the wall on the hinge side so
that the door can be opened by 90°.
26
Changing over the door hinges
The door hinges cannot be changed
over on this appliance.

Fitting the wall spacer

Fig. -
If available:
Fit wall spacers to obtain the indicated
energy absorption of the appliance.
A reduced wall gap will not restrict
the function of the appliance. The energy
absorption may then change slightly.