Makita LS1013 Instruction Manual page 13

Sub-fence
This tool is equipped with the sub-fence. It should be positioned
as
shown
in Fig. (A).
However, when performing left bevel cuts, set
it
to the left position as shown in Fig ( 6 )
I I
Fig. (A) Fig. (E
Sub-fence
R
(optional accessory)
The sub-fence R can be installed on the
right side of the guide fence. Insert the
-ods of the sub-fence R into the holes in
the guide fence. Tighten the screws which
:ome with the sub-fence R to secure the
sub-fence R.
CAUTION:
When performing right bevel cuts, never
use the sub-fence R. It will contact the
blade or some part of the tool, causing in
serious injury to operator.
Vertical vise
The vertical vise can be installed in two
positions on either the left or right side of
the guide fence or the base. Insert the vise
rod into the hole in the guide fence or the
base and tighten the screw on the back of
the guide fence to secure the vise rod.
Position the vise arm according to the
thickness and shape of the workpiece and
secure the vise arm by tightening the
damp screw. If the screw to secure the
vise arm contacts the guide fence, install
the vertical vise on the base, using the hole
19 i S
ews
Screw
I
1 '
\Guide fence
in the base. Make sure that no part of the tool contacts the vise when lowering the handle
fully or when pulling or pushing the carriage.
13