Emergency Tiller Operation - Hunter 27 the EDGE Operator's Manual

EMERGENCY TILLER OPERATION

If the situation arises where the rudder assembly is not functioning
properly and affecting your steering, Hunter has available an
emergency tiller to provide the required maneuverability. The
emergency tiller comes standard for European boats and optional for
all other destinations.
If your standard steering is experiencing a problem, inspect the
rudder's upper bearing, lower bearing and bearing rods for damage
or obstruction (see page 73). If the situation can not be remedied,
proceed with the following steps to assemble the emergency tiller for
low-speed steering.
1. Idle the boat
2. Remove the emergency tiller components from its packet
3. Ensure all parts are present (see Emergency Tiller
Components drawing, page 83)
4. Place the rudder in the down position
5. Secure the downhaul line on cleat
6. Locate the drag link mounting bracket on the front section of
the upper bearing
7. Loosen the fastener securing the bracket and free the rudder
from the steering wheel
8. Remove the lock nut which secures the drag link using the
Control Arm Release Bar
9. Check the rudder freely turns
10. Insert Tiller Handle on top of Tiller Base and secure with the
safety pin
11. Place the tiller handle assembly onto rudder bracket with
keyway slots fitting over bracket tabs
You are now able to manually steer your boat. Proceed to the closest
location for standard steering system review and repairs.