Table of Contents
Advertisement
5-1 The Machine Doesn't Run.
The Printer Unit Doesn't Run.
Is the power switched on?
Switch on the printer's main power, then press the sub power
switch and make sure the POWER light comes on.
If the [SETUP] light on?
Printing is not performed when the [SETUP] light is not on.
Pull back the loading lever, close the front cover, and press
the [SETUP] key.
Is the front cover open?
Close the front cover.
Is the top screen displayed?
W 1200mm
the computer. Press
Is the
light on?
When the
light is on, operation is paused. To re-
sume, press
key. The
printing resumes.
Has ink run out?
1
2
3
4
appears and a warning beep sounds. At the same time, op-
eration pauses. When the ink cartridge is replaced with a
new one, printing or cutting starts.
Is a message displayed on the screen?
p 108 "If a Message Appears"
p 109 "If an Error Message Appears"
Is the cable connected?
Connect the cable securely.
102
Chapter 5 What to Do If
If the top screen isn't dis-
played, printing doesn't start
even when data is sent from
key to display the top screen.
light goes dark and
When printing data is sent
while the screen shown in the
figure is displayed, a message
The Print Heater and Dryer Don't Warm Up.
Is media loaded?
The print heater does not get hot when the [SETUP] light is
dark (unless the default setting has been changed). Load
media, and wait for the machine to warm up.
p 79 "Determining How the Print Heater and Dryer Operate"
Is the temperature of the room too low?
Use the machine in an environment where the temperature
is 20 to 32˚C (68 to 98˚F).
Is the voltage switch set correctly?
Set the voltage switch correctly to match the voltage in the
region where you're using the machine.
For more information, refer to the "Setup Guide."
Advertisement
Table of Contents
