Table 116 Packet Filter Logs; Table 117 Icmp Logs - ZyXEL Communications p-334whd User Manual

Table 115 TCP Reset Logs (continued)
LOG MESSAGE
Firewall session time
out, sent TCP RST
Exceed MAX incomplete,
sent TCP RST
Access block, sent TCP
RST

Table 116 Packet Filter Logs

LOG MESSAGE
[TCP | UDP | ICMP | IGMP |
Generic] packet filter
matched (set:%d, rule:%d)

Table 117 ICMP Logs

LOG MESSAGE
Firewall default policy: ICMP
<Packet Direction>, <type:%d>,
<code:%d>
Firewall rule [NOT] match: ICMP
<Packet Direction>, <rule:%d>,
<type:%d>, <code:%d>
Triangle route packet forwarded:
ICMP
Packet without a NAT table entry
blocked: ICMP
Appendix G Log Descriptions
DESCRIPTION
The router sent a TCP reset packet when a dynamic firewall
session timed out.
The default timeout values are as follows:
ICMP idle timeout: 3 minutes
UDP idle timeout: 3 minutes
TCP connection (three way handshaking) timeout: 270 seconds
TCP FIN-wait timeout: 2 MSL (Maximum Segment Lifetime set in
the TCP header).
TCP idle (established) timeout (s): 150 minutes
TCP reset timeout: 10 seconds
The router sent a TCP reset packet when the number of
incomplete connections (TCP and UDP) exceeded the user-
configured threshold. (Incomplete count is for all TCP and UDP
connections through the firewall.)Note: When the number of
incomplete connections (TCP + UDP) > "Maximum Incomplete
High", the router sends TCP RST packets for TCP connections
and destroys TOS (firewall dynamic sessions) until incomplete
connections < "Maximum Incomplete Low".
The router sends a TCP RST packet and generates this log if you
turn on the firewall TCP reset mechanism (via CI command: "sys
firewall tcprst").
DESCRIPTION
Attempted access matched a configured filter rule (denoted by
its set and rule number) and was blocked or forwarded
according to the rule.
DESCRIPTION
ICMP access matched the default policy and was blocked
or forwarded according to the user's setting. For type and
code details, see
ICMP access matched (or didn't match) a firewall rule
(denoted by its number) and was blocked or forwarded
according to the rule. For type and code details, see
Table 126 on page
The firewall allowed a triangle route session to pass
through.
The router blocked a packet that didn't have a
corresponding NAT table entry.
P-334WHD User's Guide
Table 126 on page 268.
268.
263