Table of Contents
Advertisement
Folding Propeller Installation
1. Install the blades onto the folding propeller's hub using
the steel pins supplied. Install the socket head set screw
provided in the folding propeller's hub. This set screw will be
used to tighten the folding propeller to the motor's shaft.
2. Install the spinner onto the folding propeller's hub using
the bolts provided as shown above
3. Install the folding prop onto the motor's shaft and
tighten the hub's set screw.
Final Hookups & Checks
1. The canopy is held in place with a rubber band. Loop a
medium size rubber band through the cut-out in the rear
canopy brace. Thread the rubber band through itself and then
hook it on the little extension on the fuselage former.To remove
the canopy, pick up on the back until the dowel is clear of the
fuselage. To reinstall the canopy just do the opposite.
2. Trim the covering at the bottom of the airplane to open
the outlet holes. This will allow the cooling air for the motor
and motor battery to exit the fuselage.
Note: A piece of self-adhesive foam rubber weather stripping
(not included) can be applied to the front of the fuselage
bottom to help protect it from getting nicked up during landings.
Radio Settings
Use the sketch to make sure the control surfaces are
moving the correct directions.
10
Advertisement
Table of Contents
