Open Door By Entering Administrator Password; Forgot Administrator Password; Adding A User - ZKTeco X7 User Manual

 Open Door by Entering Administrator Password
1. The administrator password
is authenticated.
Note: This function can be used to open the door.
 Forgot Administrator Password
If administrator password is lost, you may reset the password to default through
tamper switch. Dismantle the device and wait for 30 seconds until a short beep is
heard, then press the Tamper Switch three times to reset to the initial administrator
password, this operation must be done within 30 seconds.
Note: The default administrator password is 1234.
1.2 Adding Users
Register the fingerprint or card of a user or register cards in batches.
 Adding a User
1. The
administrator is
authenticated.
Note:
1. Five digits user ID is automatically verified, if user ID is less than five digits, press [#]
to confirm.
2. If the user ID is not available, the ID number increases automatically. It continues to
register new one once a user is successfully registered.
3. The registration fails if the user ID, fingerprint or the card has been registered (the
2. Press [0] or [#].
(The indicator turns green
and makes a long beep.)
5.Exit.
(The indicator turns red and
makes a long beep.)
(Press fingers three times or swipe the card once.)
2. Press [1].
3. Input user ID twice
(The indicator turns
green and makes a
long beep.)
(Press [*], the indicator
turns red and makes a
3. Press [0] or [#].
(The indicator turns green and
makes a long beep.)
4. The door is opened
(The indicator turns green and
makes a long beep.)
4. Register fingerprint or card.
4. Register fingerprint or
card. (Press fingers three
times or swipe the
6. Exit.
long beep. )
2
card once.)
5. Registration succeeds.
(The indicator turns green
and makes a long beep.)