Pairing And Unpairing Rf Remote Controls; Pairing And Unpairing Rf Sensors - Heatrae Sadia ADVANCE Installer Manual

4.6. Pairing and unpairing RF remote controls

4.6.1. Pairing an RF-VI remote control
Consult the manual supplied with the RF-VI for information on
pairing this wireless remote control.
4.6.2. Pairing RF remote controls
It is best to pair wireless switches with a ventilation unit in the
vicinity of that unit.
a) Disconnect power to the ventilation unit.
b) Wait for at least 15 seconds.
c) Restore power to the ventilation unit.
d) Within two minutes after powering up the ventilation unit, press
two diagonally opposite buttons on the RF control switch at the
same time.
The control switch is paired, and the ventilation unit briefly changes
the motor speed to confirm the pairing. The ventilation unit is now
ready to be operated using the wireless control switch.
4.6.3. Unpairing an RF-VI remote control
Consult the manual supplied with the RF-VI for information on
unpairing this wireless remote control.
4.6.4. Unpairing RF remote controls
It is best to unpair wireless RF remote controls from a ventilation
unit in the vicinity of that unit.
a) Disconnect power to the ventilation unit.
b) Wait for at least 15 seconds.
c) Restore power to the ventilation unit.
d) Within two minutes after powering up the ventilation unit, press
the four buttons on the control switch at the same time.
The ventilation unit will now no longer respond to the wireless
control switch(es). Unpairing one control switch automatically
unpairs all control switches, controls and RF sensors.
Note
If several wireless switches, controls and/or RF sensors were
paired with the unit in question, they must be individually re-
paired after being unpaired.

4.7. Pairing and unpairing RF sensors

4.7.1. Pairing RF sensors
Pair wireless sensors with the ventilation unit as follows:
a) Disconnect power to the ventilation unit.
b) Wait for at least 15 seconds.
c) Restore power to the ventilation unit.
d) Ensure that a pairing message is sent from the RF sensor within
two minutes after power to the ventilation unit is switched on.
For more information, consult the documentation for the
relevant sensor.
The RF sensor is paired, and the ventilation unit briefly changes the
motor speed to confirm the pairing. The ventilation unit is now
ready to respond to the signals of the wireless sensor.
4.7.2. Unpairing RF sensors
RF sensors can only be unpaired at the same time as an RF remote
control. For more information, see the procedure Unpairing an RF-
VI remote control or Unpairing RF remote controls on page 27.
Note
If several wireless switches, controls and/or RF sensors were
paired with the unit in question, they must be individually re-
paired after being unpaired.
27