Network IR Dome Camera
SAFETY
When installing your Ax46/66 camera be sure to avoid:
•
excessive heat, such as direct sunlight or heating appliances
•
contaminants such as dust and smoke
•
strong magnetic fields
•
sources of powerful electromagnetic radiation such as radios or TV transmitters
•
moisture and humidity
•
areas with mechanical vibrations
•
fluorescent lamps or objects that reflect light
•
unstable light sources as this may cause flickering
•
temperatures below -30°C (-22°F) and above 60°C (140°F)
For more details on installation and operation, please refer to the CD provided.
•
POWER SUPPLY
Ensure the supplied voltage meets the power consumption requirements of this camera before
powering the camera on. Incorrect voltage may cause irreparable damage to the video camera
and will effectively void the camera warranty. PoE power is supported by this camera series. To
mount the camera, do the following:
CLEANING
•
For maximum optical clarity, the camera dome or lens must remain clean. Use a soft, dry
cloth to remove finger prints or dust from the dome cover.
•
Use a blower to remove dust from the lens.
•
Clean the body with a soft, dry cloth. If it is very dirty, use a cloth dampened with a small
quantity of neutral detergent, then wipe dry.
•
Do not use volatile solvents such as alcohol, benzene, or thinners, as they may damage the
surface finishes.
SERVICING
To avoid electrical shock and to preserve the product warranty, DO NOT disassemble the camera.
Refer servicing to qualified personnel only.
PACKAGE CONTENTS
1.
Drill Template sticker x1
2.
Waterproof RJ45 connector (x1 package with 4 pcs).
Use to protect RJ45 cable connector from the elements.
3.
Standard RJ45 connector x2
4.
Torx key x1
5.
Plastic Anchor x3
6.
Round Head Screw (Tapping type) x3
7.
User Manual and Annexxus Finder CD x1
1
1
2
A
Drill Template
Hole A: for cables routed through the ceiling
Screw hole 1: for Mounting Base
1
1
3
i3-TRNG-CAMS-Ax46_66-Series-Quick-Guide.indd
User Guide
IP Finder
4
5
6
7
Quick Start Guide
CAMERA PARTS AND DEFINITIONS
Ø111mm (4.4")
Ø79.1mm (3.1")
Mounting Base
Tilt Bracket
(Tilt to adjust
lens angle)
Lens base
(Rotate to
adjust lens
angle)
Lexan Bubble
Connect the PoE or DC12V power
connector.
PoE (IEEE 802.3af): Connect the RJ-45
connector to a PoE compatible network
Cables
device that supplied power through the
Ethernet cable.
DC12V: Connect the DC12V power
connector to a DC12V power source.
WARNING! DO NOT connect both
PoE and DC12V power connectors
at the same time. For DC power
supply use, make sure the polarity is
correct to avoid malfunction and / or
camera damage.
DC Power
Network /
PoE Power
Ax46/66-series
Side Cable
Opening
Camera Lens
Assembly
(Rotate to adjust
lens angle)
IR Board
Lens
Inner Liner/
Shroud
Safety
Cord
Rev.
151204