GGP ITALY SPA 102 Owner's Manual page 89

(2), rotate it so the spokes
point towards the seat and
push it in until the steering
wheel hub attaches to the
protruding ends of the pin
(3).
Fasten the steering wheel
in place using the screws
supplied (4 – 5 – 6), in the
indicated order.
Be careful to assemble the
cup washer (5) with the
concave part facing down
and tighten the screw (6)
with a pipe wrench.
Fit the steering wheel
cover (1a) by clicking the
fasteners into place.
3.3 FITTING THE SEAT
Raise the adjustment lever
(3) and fit the seat (1) in
the slide (2), introducing it
from the steering wheel's
side, till the seat engages
in one of the 6 positions.
EN 10
5
6
5
4
1
2
3
1a
4
2 1
At this point the seat is engaged and cannot be completely re-
moved unless the lever (4) is pressed, freeing it from its retainer.
3.4 ASSEMBLY AND CONNECTING THE BATTERY
Position the battery (1) in its compartment under the seat.
Connect the red cable (2)
to the positive terminal (+)
and the black cable (3) to
the negative terminal (–)
using the supplied screws
and following the illus-
trated sequence.
Fit the spring (4) to hold
the battery in place and
make sure all the wires are
in front of the battery so
that they don't get caught
in the spring (4).
IMPORTANT
to the instructions in the battery's manual (
IMPORTANT
tronics card from cutting in, never start the engine until the bat-
tery is fully charged!
WARNING!
3
structions regarding safe handling and disposal.
1
4
Always fully charge the battery according
6.2.3).
To prevent the safety device in the elec-
Follow the battery manufacturer's in-
3
2