GGP ITALY SPA 102 Owner's Manual page 101

WARNING!
This
should always be per-
formed on both wheels,
positioning them at the
same height WITH THE
ENGINE OFF AND
BLADES DISENGAGED.
Model 122
The three different front and rear wheel assembly positions al-
low you to maintain a safe distance «A» between the cutting
deck edge and the ground.
To change the position, release the stop plate (2) using a
screwdriver and extract the pin (3) and the spring (4).
Move the wheel (1) to the desired position, then replace the
pin (3), the spring (4) and the stop plate (2) in the indicated or-
der, making sure the pin head (4) is facing toward the inside
of the machine.
WARNING!
This should always be performed
on all wheels, positioning them at the same height
WITH THE ENGINE OFF AND BLADES DISENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– only use the blade ( 4.9), on grass lawns, do not use the
blades on stony ground or when the grass is very high;
– start moving forwards onto the grass area very gradually and
with particular caution, as already described;
EN 22
2
3
4
1 2
– adjust the forward speed and the cutting height (
cording to the lawn condition (height, density and dampness
of the grass).
WARNING!
When cutting on sloping ground, the
forward speed must be reduced to ensure safe condi-
tions ( 1.2 - 5.5).
In any case, the speed should always be lowered if you note a
reduction in engine speed, since a forward speed that is too fast
compared to the amount of grass being cut will never mow the
grass well.
Disengage the blades and put the cutting deck in the highest po-
sition whenever you need to get past an obstacle.
5.4.6 Emptying the grass-catcher
NOTE
This operation can only be done with the
blades disengaged, otherwise the engine stops.
Do not let the grass-catcher become too full as this may block
the collector channel.
When the grass-catcher is full there is an intermittent audible
warning. At this point:
– lower the engine speed;
– go into neutral (N) ( 4.32) and stop forward movement;
– disengage the blades (
– engage the parking brake on slopes;
4.10) ac-
4.9) and the audible signal will stop;