Operation Navigation Radios; Pairing/Connecting Your Phone; Make Discoverable; Switch To Next Device - iSimple CarConnect Owner's Manual

CarConnect
Smartphone Integration Interface
Installation/Owner's Manual

Operation Navigation Radios

Entering The Mode Select Menu (Navigation Radios)
Press the "XM" tab on the screen, "Select Source" will be displayed on the screen. Immediately turn the
Tune Knob to scroll through available sources (SAT Radio, Bluetooth). Once "Bluetooth" is displayed, after
10 seconds the source will auto select. If the vehicle is not equipped with factory satellite the radio will not
go into the mode select menu and the module will default to the Bluetooth mode.
Selecting Bluetooth as a source (Non-Navigation) Radios
Press the "BAND" button a few times until you enter the XM source. "Select Source" will be displayed on the
screen. Immediately turn the Tune Knob to scroll through available sources (SAT Radio, Bluetooth). Once
"Bluetooth" is displayed, after 10 seconds the source will auto select. If the vehicle is not equipped with
factory satellite the radio will not go into the mode select menu and the module will default to the Bluetooth
mode.

Pairing/Connecting Your Phone

When the CarConnect has been installed for the first time, or whenever you clear all paired devices, it will
be automatically discoverable. Open up your phone's Bluetooth menu and search for devices. Once you
see "Car Connect 3000" in the list, select it. Your phone should pair and then connect with the interface. The
CarConnect will alllow up to 4 devices to be paired at once.

Make Discoverable

Enter the mode select menu and turn the Tune Knob until "Settings" is displayed on the radio. Press the ►I
Seek button again to enter Settings. "BT Config" will be displayed on the radio. Press the ►I Seek button
again to enter the configuration menu. "Pair New" will be displayed on theradio. Press the ►I to make the
CarConnect discoverable. The radio will display "Discoverable".

Switch to Next Device

Enter the mode select menu and turn the Tune Knob until "Settings" is displayed on the radio. Press the ►I
Seek button again to enter Settings. "BT Config" will be displayed on the radio. Press the ►I Seek button
again to enter the configuration menu. Turn the Tune Knob until "Next Device" is displayed on the radio.
Press the ►I Seek button again to switch to the next device. The CarConnect will always try to connect to
the last device paired when the key is cycled. If that device is not present it will look for the next device in line.

Clear All Devices

Enter the mode select menu and turn the Tune Knob until "Settings" is displayed on the radio. Press the ►I
Seek button again to enter Settings. "BT Config" will be displayed on the radio. Press the ►I Seek button
again to enter the configuration menu. Turn the Tune Knob until "Delete All" is displayed on the radio. Press
the ►I Seek button again, the radio will display "Confirm Delete". Press the ►I Seek button again to delete
all paired devices. The radio will display "Devices Cleared".
iSimple a Division of AAMP of America | Clearwater, Florida 33760 | Ph. 866-788-4237
®
Rev. 100214
support@isimplesolutions.com | www.iSimpleSolutions.com
©2014 AAMP of Florida, Inc.
Page 3