Each Setting And Adjustment; Necessary Items To Be Noted; Updating Of The Firmware - Pioneer DJM-2000 Service Manual

5

8. EACH SETTING AND ADJUSTMENT

8.1 NECESSARY ITEMS TO BE NOTED

It is recommended that you take note of the setting data before starting repair.
Use "8.6 SHEET FOR CONFIRMATION OF THE USER SETTINGS" for taking notes.
Before repairing, be sure to check the version of the firmware (using "Page00: Version" of Test mode),
and if it is not the latest one, update to the latest version.
Perform the each item when the following parts are replaced.
• MAIN Assy (Flash ROM)
• PCIF Assy
• EEPROM (IC2003) on the PCIF Assy
• Touch Panel

8.2 UPDATING OF THE FIRMWARE

<Prerequisite>
The network settings for the PC to be used for updating must be DHCP or Auto IP.
<Procedures>
1. Download the folder for updater files to the PC, via the Internet.
Folder name: DJM2000_Ver0.00.zip ("0.00" represents the version)
2. Unzip the downloaded folder.
The following two files are unzipped:
DJM2000_Vero.oo.upd
DJM2000_Update0.00.exe (Updater application)
3. Disconnect the PC from the network then connect it with the DJM-2000.
Note: Directly connect the PC and DJM-2000, using a LAN cable. Either a straight or cross LAN cable can be used.
4. Start up the DJM-2000 in Update mode.
∗: Turn the POWER switch ON while holding the BEAT EFFECT ON/OFF and TOUCH PANEL EFFECT ON/OFF.
5. Start the DJM2000Update0.00.exe file then select the language to be used during the updating process.
5
6
• Confirmation of the version of the firmware
• Updating to the latest version of the firmware
• Confirmation of the version of the firmware (USB)
• Updating to the latest version of the firmware
• Writing of the program (USB firmware) in Checker mode (See 8.3.)
• Updating to the latest version of the firmware
• Calibration Adjustment (See 8.4.)
DJM-2000
6
7
7
8
A
B
C
D
E
F
45
8