Advertisement
ELECTRICAL CONNECTIONS
Before making the electrical connections,
check that:
l the ground cable is 2 cm longer than the
other cables;
l the system ratings meet the ratings indi-
cated on the identification plate fixed on
the lower part of the work top;
l the system is fitted with efficient earth-
ing compliant to the laws and regulations
in force.
Earthing is obligatory by law.
Live should be wired to terminal 'L'.
Neutral should be wired to terminal 'N'.
Earth should be wired to terminal 'E' or
If the domestic appliance is not fitted with
a cable and/or relevant plug, use material
suited to the absorption value indicated on
the identification plate and the operating
temperature.
At no point must the cable reach a tem-
perature 50°C higher than room tempera-
ture.
If wishing to make a direct connection to
the mains, an omnipolar switch must be
interposed with a minimum opening of 3
mm between the contacts and suited to
the load indicated on the plate and con-
form to the regulations in force (the yel-
low/green ground conductor must not be
interrupted by the switch). When the
appliance has been installed, the omnipo-
lar switch must be easily accessible.
USE AND MAINTENANCEMAINTENANCE
Remove any residues of food and drops of
grease from the cooking surface using the
special scraper supplied on request (Fig.5)
fig 5
Instructions
Clean the heated area as thoroughly as
possible using SIDOL, STAHLFIX or similar
products and a cloth/paper, then rinse with
water and dry with a clean cloth. Using
the special scraper (optional) immediately
remove any fragments of aluminium and
plastic material that have unintentionally
melted on the heated cooking area
or residues of sugar or food with a high
sugar content (Fig.5).
In this way, any damage to the cook top
surface is prevented.
Under no circumstances use abrasive
sponges or irritating chemical detergents
such as oven sprays or stain remover.
USE
Use the control knobs to set the desired
power. Turn them clockwise to maximum.
In the case of plates with a double area,
the external heating element can be
switched on starting from zero and
turning in an anticlockwise direction.
The hit hob lights are ON when:
l the top temperature at the Indicated
spot is higher than 50°C.
THE MANUFACTURER DECLINES ALL
RESPONSIBILITY FOR EVENTUAL
DAMAGES CAUSED BY BREACHING
THE ABOVE WARNINGS.
2
Advertisement
