Table of Contents
Advertisement
180 Network Settings (Network)
Key Type drop-down
list button
WEP key
WEP Key Type radio
buttons
WEP key field
Detail Setting button
Authentication
drop-down list button
9.
Make the same settings as the access point.
If necessary, tap "Detail" to enter the WEP keys.
On the Detail screen, enter the WEP keys and tap the radio button of the selected
WEP key and then tap
screen where you can edit the selected WEP key.
10.
Tap "Next".
The next screen for the Proxy setting appears.
Tap the Proxy drop-down list button and then tap the desired type.
There are two types of setting options.
Selects the encryption key length from the following:
Disabled, 40bit (64bit), 104bit (128bit).
Selects the encryption key format, Text or Hex and enter
the characters as follows:
Text: 5 characters for 40 bit (64 bit), or 13 characters for
104 bit (128 bit).
Hex: 10 characters for 40 bit (64 bit), or 26 characters for
104 bit (128 bit)
The character number necessary for the WEP key is
displayed on the left of the radio buttons.
Enter the encryption key set in the Key Type section.
If the Key type is set to "Disabled", this field is not used.
Tap to set several WEP keys according to your access
point requirements.
Selects the way of the authentication of the access point:
Open System or Shared Key.
. The Detail screen returns to the previous WEP setting
Advertisement
Table of Contents
