Video; Video Mode - Yamaha Aventage RX-A1050 Owner's Manual

Video

Configures the video output settings.
■

Video Mode

Enables/disables the video signal processing (resolution and aspect ratio).
Settings
Direct Disables the video signal processing.
Enables the video signal processing.
Processing
Select a resolution and an aspect ratio in "Resolution" and "Aspect".
• When "Video Mode" is set to "Direct", the unit transmits video signals with the least circuitry in order to
reduce video output delay.
• When "Video Mode" is set to "Processing" and the resolution is being converted, short messages are not
displayed on the TV screen.
Resolution
Selects a resolution to output HDMI video signals when "Video Mode" is set to
"Processing".
Settings
Through Does not convert the resolution.
Auto Selects a resolution automatically in accordance with TV resolution.
Output video signals with a selected resolution.
480p/576p, 720p,
1080i, 1080p, 4K
(Only the resolutions supported by your TV are selectable.)
• If you need to select a resolution that is not supported by your TV, set "MONITOR CHECK" (p.133) in
the "ADVANCED SETUP" menu to "SKIP" and try again. (Note that the output video may not be
displayed on your TV normally.)
Aspect
Selects an aspect ratio to output HDMI video signals when "Video Mode" is set to
"Processing".
Settings
Through Does not convert the aspect ratio.
Outputs 4:3 video signals to a 16:9 TV with black bands on either side
16:9 Normal
of the screen.
• This setting functions only when 480i/576i or 480p/576p signals are converted into 720p, 1080i,
1080p, or 2160p (4K) signals.
119
En