Hitachi AMS 2100 Getting Started Manual page 48

12.Check all of the hosts to which you want the storage system to connect.
13.When you finish, click Next.
14.Review your selections in the next two confirmation pages:
• If no changes are required, click Next.
• If you need to change a selection, click Back to return to the
appropriate page, make the desired changes, and then click Next
to return the first confirmation page and verify that the change
was made.
• At the last confirmation page, click Confirm to commit your
selections.
15.The next page confirms that the Create & Map Volume Wizard completed
successfully. To create additional RAID groups, logical units, and host
groups, click Create & Map More LU and repeat this procedure.
Otherwise, click Finish.
15. Add the newly configured storage system to Navigator 2
After you configure both controllers, perform the following procedure to add
the newly configured storage system to Navigator 2.
1. If the Arrays page is not displayed, click Arrays in the left pane.
2. From the Arrays page, check the storage system you just configured
under the Array Name column.
3. Click Remove Array to remove the selected base unit from the Arrays
area.
4. When the message indicates that the base unit was removed
successfully, click Close to remove the message.
46
Figure 1-39: Connect to Hosts Page
Hitachi AMS 2100/2300 Getting Started Guide