Hitachi AMS 2100 Getting Started Manual page 44

separate download. Then change the Registry setting for Persistent
Reservation as required. Exercise care when setting this value. If
set incorrectly, the server may not operate normally.
• Unique Reserve Mode setting on the storage system.
Check Enable Unique Reserve Mode 1.
• If you use an alternate path (MPIO:Multipath I/O) configuration on
Windows Server 2008, open MPIO on the Windows Control Panel and
register HITACHI DF600F as an MPIO device.
• If connecting with a Tru64 host, select Not specified from the
Platform drop-down list. Do not select HP-UX for Tru64.
NOTE: Discovery CHAP Mode is not used with Fibre Channel, even if this
option appears to be selectable and checked.
6. Click the OK button in the lower right corner of the page.
7. Click the Close button.
8. Go to
Create RAID groups, logical units, and host groups
The following sections describe how to create RAID groups, logical units,
and host groups. For additional information, refer to the Navigator 2 online
help.
NOTE: If LUN Manager is not installed or enabled in the storage system,
or if host group security is disabled or host group assignment is skipped, a
screen appears at the end of this procedure to inform you that Navigator 2
automatically assigns logical units to all hosts connected to the selected
port.
1. If the Common Array Tasks area is not displayed, click the storage
system under the Array Name column in the Arrays page.
2. In the Common Array Tasks area, click Create Logical Unit and
Mapping. The Create & Map New Volume wizard starts.
42
Create RAID groups, logical units, and host groups on page
Hitachi AMS 2100/2300 Getting Started Guide
42.