4. In the IP Address or Array Name of controller field, enter the same
controller IP addresses recorded in
note on
a management port on one controller or connected using a switch or
hub.
5. Click OK.
6. When the page tells you that the storage system information has been
edited successfully, click Close.
Select platform-specific settings
To connect to hosts running the following host operating systems and
clustering solutions, use Navigator 2 to configure the storage system's host
groups and iSCSI targets as described in the following procedures.
•
AIX
•
HP-UX
•
NetWare
•
TruCluster
•
Veritas Cluster Server
Figure 1-27: Example of Edit Array Page
page 29
regarding management consoles directly connected to
•
Apple Macintosh
•
Microsoft Windows 2000 Server, Windows Server
2003 and 2008, Windows XP, Vista
•
Red Hat Enterprise Linux, SUSE Linux Enterprise,
Asianux
•
Solaris
•
VMware
Hitachi AMS 2100/2300 Getting Started Guide
Table 1-10 on page
49. Refer to the
35