Assembly - Master TENTEvent125 TB116A Owner's Manual

ASSEMbLY ITEMS
Before assembling heater, make sure you have the items listed below.
• Phillips head screwdriver
• Wrench
• Hardware packet
Handles (2), 3/4" Screws (4), 1/4-20 Nuts (4), 1/4 Flat washers (4), 1/4 Lock washers (4)
Casters (2), 3/8" Nut (2), 3/8 Lock washers (2), 3/8 Flat Washers (4)
Wheels (2), Cotter Pins (2)
Brackets (4), 1/2" black screws (8), 3/8" screws (8)
Note: Place metal parts on packaging during assembly to protect from scratches.
Side Handles
1. Remove handles, 3/4" screws, 1/4-20
nuts, 1/4 flat washers and 1/4 lock wash-
ers from hardware packet.
Casters
1. Remove casters, 3/8 flat washers, 3/8
lock washers and 3/8 nuts from hardware
packet.
2. You may wish to remove side panel from
heater to make installing casters easier.
If so, see Top and Side Panel Removal
on page 14. Figure 4 shows side panel
removed for clarity.
3. Use a spacer to prop end of heater up
so holes in base can be accessed (the 2
wheels stacked on top of each other will
accomplish this).
4. Place a flat washer onto threaded stem of
caster. Insert caster stem through hole in
cabinet base as shown in Figure 4.
5. Attach each caster to base with a flat
washer, a lock washer and a nut as shown
in Figure 4.
120942-01E

aSSeMBLy

2. Attach each handle to side panels with 2
Figure 3 - Attaching Handles
www.desatech.com
screws, 2 nuts, 2 flat washers and 2 lock
washers. Insert screw from outside of
heater and through handle. From inside
of heater, attach a flat washer, then a lock
washer then a nut as shown in Figure 3.
Nut
Lock Washer
Flat Washer
Nut
Lock Washer
Flat Washer
Caster
Figure 4 - Installing Casters
Handle
Screw
9