HEAT ONLY SERIES High Efficiency Heat Only Boilers THE BENCHMARK SCHEME In order to comply with Building Regulations Part L (Part J in Scotland) the boiler MUST be fitted in accordance with the manufacturer’s instructions. Benchmark places responsibilities on both manufacturers and installers. The purpose is to ensure that customers are provided with the correct equipment for their needs, that it is installed, commissioned and serviced in accordance with the manufacturer’s instructions by competent persons and that it meets the requirements...
CONTENTS Benchmark Scheme General Information Layout of the User Panel Initial Lighting Operation of Boiler Reset Function Error Codes Flame Loss Boiler Overheating Condensate Drain Servicing & Maintenance Escape of Gas Cleaning the Appliance Notes Telephone: 01604 762881...
GENERAL INFORMATION Part of the installation and commissioning of this appliance is related to instructions for use by the heating engineer to the user where specific requirements may occur, see note below. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for...
INITIAL LIGHTING If turning on the boiler for the first time carry out the following steps: Check that the electrical supply to the boiler is ON at the external isolator. Ensure all hot taps are closed. Set any remote controls as required. Turn the CH control P1 to the minimum setting.
BOILER OVERHEATING In the event of the boiler overheating the boiler will lockout and an error code will be displayed in the series of LED’s as detailed below. Turning the central heating water temperature control P1 to the OFF position and then back on again will clear the error and enable the boiler to relight.
Page 8
Johnson & Starley Johnson & Starley are the leading UK & European manufacturers of a complete range of Domestic Warm Air Heaters. All the heaters suit both Replacement and Upgrade needs and are compliant with the new (2006) amendments to Part L of the Building Regulations.
Need help?
Do you have a question about the Reno HE16H and is the answer not in the manual?
Questions and answers