Acura TL 2012 Owner's Manual page 79

Blind Spot Information
System (BSI) Indicator
On models with blind spot information
system (BSI)
This indicator normally comes on for
a few seconds when you select the
ON mode by operating the engine
start/stop button (see page
This indicator comes on as a
reminder that you have
turned off the blind spot
information system (BSI).
When you turn the system on, the
indicator will turn off.
The BSI indicator also comes on if
the rear bumper becomes dirty while
driving. You will see a ''BLIND
SPOT NOT AVAILABLE'' message
on the multi-information display.
When you clean the rear bumper,
the indicator should go off after you
begin driving again.
If the indicator comes on at any
other time, there is a problem with
BSI. You will also see a ''CHECK
BLIND SPOT SYSTEM'' message
on the multi-information display. If
this happens, take your vehicle to a
dealer, and have it checked. For
185 ). more information, see page
When this indicator is on,
BSI is not working.
519 .
I n f o r ma t i o n P r o v i d e d b y :
2012 TL
Instrument Panel Indicators
75