Drive Chain Check, Adjustment And Lubrication - Regal Raptor DAYTONA 125 User Manual

DRIVING CHAIN CHECK, ADJUSTMENT AND LUBRICATION
[Driving Chain Cheek]
Check for wear of the driving chain . Lubricate it when
it is short of oil. Use the centre stand to support the motorcycle,
and step on the gearshift pedal to shift into neutral. Place your
finger between both front and rear wheels, and swing the chain
up and down to adjust the chain to 10-20mm.
Driving chain adjustment
Loosen the nut of the rear wheel axle
nut by the chain tension, adjust the chain tension
same step. Make both left and right chain tension at the
same level. Check the tighten of the chain, if okay,then lock
the nut of rear wheel axle and the chain tension nut
[Driving Chain Lubrication]
Remove a chain lock clip
disassemble the chain. Clean the chain in the detergent solvent
and then dry it. Check for wear and damage of every part of the
chain. If necessary, replace it. Lubricate the chain with an
appropriate amount of motor oil or chain lubricant oil. Install
the driving chain in the reverse order of disassembly and adjust it.
NOTE: WHEN INSTALLING THE CHAIN LOCK CLIP, KEEP THE MOUTH OF THE
CLIP OPPOSITE TO THE NORMAL MOVING DIRECTION.
29
, and the tighten the
with pliers carefully and
at the
¢ Ü º ó Â
Â Ý Ä ¸