Riding; Running-In - Regal Raptor DAYTONA 125 User Manual

RIDING

[Shifting Gears]
Warm up the engine.
1.While the engine is idle, release the clutch, put your foot on the gearshift pedal to shift into a
low gear(first gear)
2.Gradually accelerate the engine and slowly loose the clutch handle. Coordinate them to start
riding steadily.
3.When the motorcycle rides steadily, feedback oil enables the engine to slow down, release the
clutch again and pull the gearshift pedal up to shift into second gear. It is the same for changing to
any other gear.

RUNNING-IN

During the initial running-in of 1000km,avoid full
throttle use and never labour the engine by shifting gears.
Strictly restrict the engine to less than 6000 rpm. During
the initial running-in of 500km,the maximum speed should
not be more than 55km/h and during the first 500-1000km,
no more than 70km/h. Timely performance of the running-in
maintenance will ensure optimum service life and
performance form the engine. Running-in speed in every
gear is shown in the right table.
21
Running-in speed
Speed
Gear
First 0~15km/h
Second 10-30km/h
Third 20-45km/h
Fourth 30-55km/h
Fifth 50-70km/h