Operation; Using The Controls - Roksan Audio K3 Manual

!

Operation

Please refer to the front & rear panel views.
Switching On
The Mains power switch (9) is located on the front underside of the CD Player.
This switch can be left ON for normal operation. If unattended for a long
period (Going on a short break, holidays etc.) the Mains power should be
switched OFF and the power cord disconnected from the mains power input.
When switched ON, the K2 logo in the 'mirror' display will glow red and the CD
Player FL Display will illuminate.

Using the Controls

NOTE: Please refer to the front panel view on page 4.
Press the Open/Close Button (1) once to open the disc loading tray (Display
will indicate: open). Carefully load disc into the tray recess with the label side
up. Press the button again to close the tray.
NOTE: Never load a disc until the drawer has opened fully, or try to close the
drawer until you are sure that the disc is properly seated in the holder recess.
Warped discs should never be played.
The drawer should only be opened using the front panel control. Under no
circumstances should you attempt to open manually.
If a disc is not inserted or if the disc is damaged or inserted upside down, the
CD player will remain inoperative (display will indicate: no disc).
When a disc has been loaded, your K3 CD Player will briefly spin the disc while
it studies the data encoded on it. The disc will then stop and the display will
indicate the number of tracks on the disc and the total play time.
!
Roksan Audio Ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
11