Connecting Mains Power; Signal Connections - Roksan Audio K3 Manual

Hide thumbs Also See for K3:

Table of Contents

Please refer to the front & rear panel views. The moulded IEC connector of the

supplied mains lead should be plugged into the socket (13) on the rear of the

unit ﬁrst and then plugged into the mains supply. The Mains power switch (9) is

on the front underside of the CD Player. This switch can be left on; if however

the CD Player is likely to be unattended for a long period, switch it off and

unplug the mains lead from the wall.

ANALOGUE OUTPUT:

The Analogue Outputs (10) use Gold plated RCA Phono sockets and should be

connected to the CD or LINE input of your Preampliﬁer or Ampliﬁer. 

Standard convention – Right Channel – Red; Left Channel – Black or White.

DIGITAL OUTPUT:

The Digital Outputs (11) utilise; Gold plated RCA Phono socket for Coaxial

SPDIF output, Toslink for Optical output and XLR for Balanced AES/EBU output.

Any of these could be connected to a corresponding input of an ampliﬁer with

a digital input, or to an outboard Digital to Analogue converter (DAC).

IMPORTANT NOTE: For optimum performance it is recommended to use high

quality inter-connect cables such as ROKSAN HDC-03A High Deﬁnition

Analogue Cable and HDC-01D High Deﬁnition Coaxial Digital Cable.

Set-Up

Connecting Mains Power

Roksan Audio Ltd

CLASSIFICATION: General Use

All speciﬁcations are liable to change without notice. E&OE

Table of Contents