Introduction; Installation Process Overview; Controls & Indicators - DSC HSM2HOST Installation Manual

H S M 2 H O S T I n s t a l l a t i o n M a n u a l

2.1 Introduction

The HSM2HOSTx two-way wireless transceiver adds wireless capability to PowerSeries Neo alarm controllers, model HS2128, HS2064,
HS2032 or HS2016. The HSM2HOST receives signals from wireless zones and wireless keys, and provides information to the alarm controller it
is connected to. This manual describes how to install, program and maintain the HSM2HOST. Note that only one HSM2HOST or one RFK key-
pad can be enrolled on the alarm system.
Before installing:
1. Plan the placement and wiring of the security system (see system installation manual).
2. Install the control panel and optional modules.
3. Temporarily mount all wireless devices in the intended location.

2.1.1 Installation Process Overview

To install and set up the HSM2HOST and wireless devices:
1. Temporarily mount and wire the HSM2HOST module ("Choose a Mounting Location" on page 6).
2. Enroll the HSM2HOST and first wireless keypad ("Enroll The HSM2HOST" on page 6).
3. Check the location for RF interference levels ("[804][801] RF Jam Detect" on page 8).
4. Enroll wireless devices ("[804][000] Enroll Wireless Devices" on page 7).
5. Complete zone and other programming on the system ("Wireless Device Setup and Programming" on page 7).
6. Test the placement of all the wireless devices ("[904] Placement Testing Wireless Devices" on page 10).
7. Permanently mount the HSM2HOST and wireless devices ("Permanently Mount" on page 7).
2.1.2 Controls & Indicators
Status LEDs
The LEDs on the front of the HSM2HOST provide feedback regarding the installation, operation and troubleshooting of the unit. The LEDs
function as follows:
Red LED
Module Power Up: On steady during module power-up sequence then off.
Firmware Update: Slow flashing = update in progress
Very rapid flashing = update corrupt, contact distributor
Trouble Condition: •
If troubles are present, a series of flashes occur every 2 seconds. Each
series of flashes indicate troubles as follows:
•
•
•
Module Confirmation: Flashes rapidly during module confirmation process.
Placement Test: On steady when location is bad. Off when location is good.
Green LED
Placement Test: On steady when location is suitable. Off when location is unsuitable.
NOTE: For UL/ULC listed systems, signal must be "Strong". See
Wireless Device Status Indications on page 10 for details.
Tamper
The HSM2HOST has separate built-in wall and case tampers. The case tamper is disabled by default on the NA version (enabled on EU version).
Section [804][810] option 3 enables or disables the case tamper. Enable or disable the wall tamper by fastening the breakaway wall tamper
bracket securely to the wall using one of the supplied screws.
The case tamper activates when the case is opened and restores when the case is closed. The wall tamper on the back of the unit is depressed by
the mounting surface when properly installed. If the unit is removed, the tamper activates. Ensure the mounting surface is smooth and free of
obstructions that block access to the rear of the unit. Electrical wires should not run over or under the module when it is mounted.
NOTE: The built in wall and case tamper must be installed and enabled for UL/ULC listed Commercial/ Residential Burglary applications.
Operation
No trouble: 1 rapid flash every 10 seconds.
1 flash: Module not enrolled
2 flashes: Loss of contact with module for over 60 seconds
3 flashes: Corbus low voltage
Operation
5
I n t r o d u c t i o n