LTC 5104, LTC 5108 Series | Instruction Manual | Important Safeguards Important Safeguards 1. Read, Follow, and Retain Instructions - All safety and operating instructions should be read and followed before operating the unit. Retain instructions for future reference. 2. Heed Warnings – Adhere to all warnings on the unit and in the operating instructions.
LTC 5104, LTC 5108 Series | Instruction Manual | Safety Precautions For Indoor Product 1. Water and Moisture - Do not use this unit near water - for example, in a wet basement, in an unprotected outdoor installation, or in any area classified as a wet location.
LTC 5104, LTC 5108 Series | FCC & ICES Information FCC & ICES INFORMATION (U.S.A. and Canadian Models Only) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference,...
Page 5
LTC 5104, LTC 5108 Series | Instruction Manual | Safety Precautions Sicherheitshinweise VORSICHT: DAS GEHÄUSE ZUR VERMEIDUNG VON ELEKTRISCHEN SCHLÄGEN NICHT ÖFFNEN. DAS GERÄT ENTHÄLT KEINE VOM BENUTZER ZU WARTENDEN TEILE. REPARATUREN NUR VON FACHPERSONAL AUSFÜHREN LASSEN. Das Blitzsymbol im gleichseitigen Dreieck soll den Benutzer auf nicht isolierte “gefährliche Spannung”...
Page 6
LTC 5104, LTC 5108 Series | Instruction Manual | Safety Precautions Veiligheidsmaatregelen GEVAAR: OPEN DEZE BEHUIZING NIET, TENEINDE HET RISICO VAN ELEKTRISCHE SCHOKKEN TE VOORKOMEN. BINNENIN BEVINDEN ZICH GEEN DOOR DE GEBRUIKER TE REPAREREN ONDERDELEN. RAADPLEEG VOOR REPARATIE GEKWALIFICEERD SERVICEPERSONEEL.
LTC 5104, LTC 5108 Series | Instruction Manual | Unpacking UNPACKING Unpack carefully. This is electronic equipment and should be handled with care. Check for the following items: • Verify the unit model number. • One (1) cable assembly with 15-pin connector.
Bosch Security Systems | 7 April 2004 The remaining configuration menus (8 for the LTC 5104 Series and 9 for the LTC 5108 Series) are also accessed with the DWELL key. With video present on the monitor, press and hold the DWELL key for 1 second;...
LTC 5104, LTC 5108 Series | Instruction Manual | Installation • To abort and resume normal operation, press DWELL. • To reset to factory defaults, press SKIP/clr, moving the cursor to RESET, then press DWELL. This option also performs a VideoSearch.
LTC 5104, LTC 5108 Series | Instruction Manual | Installation 4.11 Alarm Capture This menu item appears only if the Auto Alarm reset mode is selected (see SCREEN 5). When the Alarm Capture is ON, alarm call ups are held for at least the length of their Alarm Capture Time.
LTC 5104, LTC 5108 Series | Instruction Manual | Installation 4.15 Status Line This menu determines what will be displayed on the on-screen Status Line. There are three options: 1. A full status line, which contains the camera number, camera title, sequence mode, and alarm status information, 2.
LTC 5104, LTC 5108 Series | Instruction Manual | Installation NOTE: These functions can be performed at a faster speed by pressing and holding the respective keys for a few seconds. NOTE: For applicable characters, see SECTION 7, FONT TABLES.
LTC 5104, LTC 5108 Series | Instruction Manual | Illustrations 6.2 LTC 5108 Series Screen 15 Front Panel and Back Panel 1 6 11 2 7 12 8 13 4 9 14 5 10 15 Screen 16 Connector Diagram Bosch Security Systems | 7 April 2004...
Page 16
EN | 16 LTC 5104, LTC 5108 Series | Instruction Manual | Illustrations DVR or VCR Screen 17 Typical Installation Using LTC 5108 Series Switcher Bosch Security Systems | 7 April 2004...