Esc T N - Citizen CT-S280 Command Reference Manual

ESC T n

support model
[Function]
Selecting the character printing direction in PAGE MODE
[Code] <1B>H<54>H<n>
[Range]
0≤n≤3, 48≤n≤51
[Outline] [The specification which is common to the model]
• Selects the direction and start point of character printing in PAGE MODE.
n
0, 48
1, 49
2, 50
3, 51
[Caution] [The specification which is common to the model]
• When STANDARD MODE is selected, this command only executes the internal flagging of the
printer without affecting the printing in STANDARD MODE.
• The character mapping position will be the start point of the print area specified by ESC W.
• The basic calculation pitch (x or y) used by the following commands varies with the start point.
(1) If the start point is the top left or bottom right (The characters are mapped in the direction perpendicular
to the paper feed),
(2) If the start point is the top right or bottom left (The characters are mapped in the paper feed direction),
[Default]
n=0
[See Also]
Appendix 5.1 "Explanation on PAGE MODE"
ESC $, ESC
CT-S280 CT-S300
CT-S281 CT-S310
Printing Direction
Left to right
Bottom to top
Right to left
Top to bottom
A
• Commands using x: ESC SP, ESC S, ESC \
• Commands using y: ESC 3, ESC J, GS $, GS \
• Commands using x: ESC 3, ESC J, GS $, GS \
• Commands using y: ESC SP, ESC S, ESC \
L, ESC W, ESC \ , GS $, GS
CT-S2000 CT-S4000
CT-S801/851 CT-S601/651
Start Point
Top left ("A" in the figure)
Bottom left ("B" in the figure)
Bottom right ("C" in the figure)
Top right ("D" in the figure)
Paper feed direction
P, GS \
- 83 -
CT-S251
CT-P29x series CT-S310 II