Esc L - Citizen CT-S280 Command Reference Manual

ESC L

Support model
[Function]
Selecting PAGE MODE
[Code] <1B>H<4C>H
[Outline] [The specification which is common to the model]
• Switches from STANDARD MODE to PAGE MODE.
[Caution] [The specification which is common to the model]
• This command is only effective if it entered at the beginning of a line.
• This command is not effective if it is entered when in PAGE MODE.
• STANDARD MODE is restored when printing specified by FF is finished or when ESC S is issued.
• The character mapping start position will be the point specified by ESC T in the print area specified by ESC W.
• The commands listed below, which have separate settings for PAGE MODE and STANDARD MODE, are
changed to the settings for PAGE MODE use.
(1) Spacing setting:
(2) Line feed width setting:
• The following commands are valid only in PAGE MODE.
(1) ESC V
(2) ESC a
(3) ESC {
(4) GS L
(5) GS W
• The following commands are disabled in PAGE MODE.
(1) GS ( A
(2) FS p
(3) FS q
(4) GS v 0
• ESC @ restores STANDARD MODE.
[See Also]
Appendix 5.1.4 "Example of using PAGE MODE"
FF, CAN,
CT-S280 CT-S300
CT-S281 CT-S310
Specifying/canceling 90°-right-turned characters.
Aligning the characters.
Specifying/canceling the inverted characters.
Setting the left margin.
Setting the print area width.
Executes test printing.
Prints NV memory bit image.
Defines NV memory bit image.
Prints raster bit image.
ESC FF, ESC S, ESC T, ESC
- 322 -
CT-S2000 CT-S4000
CT-S801/851 CT-S601/651
ESC SP, FS S
ESC 2, ESC 3
W, GS W, GS
\
CT-S251
CT-P29x series CT-S310 II