Dle Dc4 Fn D1 - Citizen CT-S280 Command Reference Manual

Hide thumbs Also See for CT-S280:

Table of Contents

DLE DC4 fn d1...d7 (Specification of fn = 8)

Support model

Buffer clear

<10>H<14>H<fn><d1> ...<d7>

fn=8, d1=1, d2=3, d3=20, d4=1, d5=6, d6=2, d7=8

[The specification which is common to the model]

• Erases all data in receiving buffer or print buffer.

• Sends the following 3-byte data group.

• Enters the state of selecting STANDARD MODE.

[The specification which is common to the model]

• When receiving a code row coinciding with the code configuring this command, the

same operation as this command takes place and attention by the user is required.

Example: When corresponding code row is present in bit image data.

• This command must not be used between other command code rows.

Example: This command is used in the bit image data.

• This command is ignored under the following conditions.

• During sending block data

CT-P29x series