Black Mark Control Commands; Gs Ff - Citizen CT-S280 Command Reference Manual

2.2.15 Black Mark Control Commands

GS FF

Support model
[Function] Printing and ejecting Black mark paper/ label paper
[Code]
<1D>H<0C>H
[Outline] [The specification which is common to the model]
• This command prints the data in the printer buffer and ejects Black mark paper/ label paper.
[The specification which depend on the model]
CT-S2000/CT-S4000/CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II)
Data in the print buffer is printed and black mark/label ejection is done by following order .
• When auto cutter enabled is selected
(1)The printed black mark/label paper is fed to the auto cutter position and full cutting is
carried out.
(2)Setting the first position of next BM paper/label paper is carried out.
• When auto cutter disabled is selected
(1)Feeds the printed black mark/label paper to the position to be cut by the manual
(2)Keeps waiting till cutting is made and FEED SW is pressed while blinking LED.
(3)If FEED SW is pressed, setting the first position of BM paper/label paper is carried out.
CT-S281
Data in the print buffer is printed and black mark/label ejection is done by following order .
• When auto cutter enabled is selected
(1)The printed black mark/label paper is fed to the auto cutter position and full cutting is
carried out.
MSW5-6=ON: When printer receives the enxt data, top of form detection is done in the way of (2).
(2)Setting the first position of next BM paper/label paper is carried out.
• When auto cutter disabled is selected
(1)Feeds the printed black mark/label paper to manual cut position or manual peel off
MSW5-6=ON: When printer receives the enxt data, top of form detection is done in the way of (2).
(2)Keeps waiting till cutting is made and FEED SW is pressed while blinking LED
(3) When FEED SW is pressed, feed the paper to detect next black mark/top of label
CT-S280 CT-S300
CT-S281 CT-S310
cutter or to be peeled off.
• The printer is in the BUSY state till the processing of (3) is executed. If, however,
FEED SW is not pressed in 3 seconds, the same operation as that with FEED SW is
executed.
position.
•MSW3-7 = ON: Keep waiting for FEED SW being pressed.
•MSW3-7 = OFF: If FEED SW is not pressed in 3 seconds (default), the same operation
as that with FEED SW is executed.
The time to wait for manual cut can be changed by <GS ( E > command.
•Printer is in BUSY state until (3) transaction is done.
•When MSW4-5=OFF (Black mark), printer feed the paper backward by about 5mm.
CT-S2000 CT-S4000
CT-S801/851 CT-S601/651
- 173 -
CT-S251
CT-P29x series CT-S310 II