Pairing Your Bluetooth Device - iHome iBT230 Instruction Manual

Pairing Your Bluetooth Device

Whenever AC power is connected, the iBT230 will attempt to autolink to a previously paired device. If no
device is paired, the iBT230 will automatically enter pairing mode for 2 minutes. You can manually initiate
pairing without turning on the iBT230 by following steps 1-3 below.
1. Make sure your Bluetooth device is fully charged. Turn on your Bluetooth device and
2. Press and hold the
pair
3. "iHome iBT230" should appear in your device's Bluetooth menu. If "Not Paired", "Not Connected" or
similar message appears, select "iHome iBT230" to connect it. If prompted for a passcode, enter "1234"
on your device's keypad.
iHome iBT230
For iPhone
4. If pairing is successful, PAIR will appear at the bottom of the display, the Bluetooth icon
solid and 2 beeps will sound, indicating the iBT230 is ready to play music. There should also be an
indication on your device. If no device is successfully paired within 2 minutes the iBT230 will default to
previous mode. Once the iBT230 is paired to a device, it will attempt to autolink when the device is
within range (about 30 feet).
make it "discoverable" by turning on Bluetooth mode (check in Options or Settings) .
pair
beep and BT and the Bluetooth
iBT230 is in pairing mode.
iHome iBT230
Play/Pause/Pairing Button for 2 seconds. The iBT230 will
icon will flash on the display, indicating the
For other
11
iBT230
Using the
iHome iBT230
iHome iBT230
will appear