Gun Routine Maintenance; Welding Power Source Overload Protection; Drive Motor Protection And Tip Saver/Short Circuit Protection - Miller Electric Renegade 180 Owner's Manual
Miller electric owner's manual welding engine driven welding power source/ wire feeder/generator renegade 180
8-4. Drive Motor Protection And Tip Saver/Short Circuit Protection
A. Drive Motor Protection
Drive motor protection circuit protects drive motor from overload. If drive motor becomes inoperative, release gun trigger and wait until protection circuit
resets allowing drive motor to feed wire again.
B. Tip Saver/Short Circuit Protection
The tip saver/short circuit protection extends contact tip life and protects internal components from damage. If contact tip is shorted to workpiece, the
unit shuts down the welding output. To resume operation, release gun trigger to reset unit. If the contact tip has stuck to the workpiece, release gun
trigger, turn off unit, and remove contact tip from workpiece. Check contact tip and replace if damaged. Turn on unit to continue operation.
OM-228 042 Page 32
Z = Change
~ = Clean
~ Nozzle, n Contact Tip
l Cracked Parts
.
Shown with optional cylinder rack
.
Complete Parts List available at www. MillerWelds.com