Engine Prestart Checks; Connecting The Battery (Electric Start Models Only) - Miller Electric Renegade 180 Owner's Manual

5-3. Engine Prestart Checks

1/2 in
(13 mm)
Full
Gasoline
1

5-4. Connecting The Battery (Electric Start Models Only)

OM-228 042 Page 18
.
Complete Parts List available at www. MillerWelds.com
Full
!
Connect negative (−)
cable last.
+
Check all fluids daily. Engine must
be cold and on a level surface. Unit
is shipped with 10W30 engine oil.
1 Fuel Valve
Open valve.
.
Fuel valve is shown in the open
position. Always close fuel
valve after stopping unit. Mov-
ing unit with fuel valve open
may cause carburetor flooding
and make starting difficult.
Fuel
Add fresh fuel before starting
engine the first time (see engine
manual for specifications). Fill fuel
tank up to 1/2 in. (13 mm) from top
to allow room for expansion. Check
fuel level on a cold engine before
use each day.
Oil
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see en-
gine manual).
Unit stops if oil level is too low. Unit
cannot be restarted until sufficient
oil is added.
804 971-A
!
Turn Engine Switch to Off
(electric start models only).
−
Tools Needed:
1/2 in
805 052-A / 803 466