Memory Switch Setting (By The Buttons On The Printer.) - Star SM-S230I SERIES Hardware Manual

3.3 Memory Switch Setting
For details on the printer settings, refer to [ Setting Table] on page 17.
The setting change by memory switch is disabled before shipment.
Before changing the printer setting by the memory switch, enable the setting change by memory switch
using the following steps.
1. Turn on the printer power by pressing and holding down the FEED button and the POWER button
simultaneously for 5 seconds or more. The printer will perform self printing.
2. The printer prints out the contents up to the QR code in case of the ESC/POS mode or the contents
up to the memory switch setting information in case of the StarLine mode. Then, release the POWER
button and the FEED button, and press the POWER and FEED buttons simultaneously within 2 seconds.
3. Hold down both buttons for 2 seconds or more and release the buttons.
4. If the printer prints out "Memory SW setting = Enabled", the setting change by memory switch is
enabled.
Emulation : ESC/POS
Communication Port : Bluetooth
* When the above steps 1 to 4 are performed while the setting change by memory switch is enabled,
the printer prints out "Memory SW setting = Disabled" and the setting change by memory switch is
disabled.
(By the buttons on the printer.)
- 14 -