Belt Clip; Attaching To The Printer; Using The Belt Clip - Star SM-S230I SERIES Hardware Manual

2.4 Belt Clip

2.4.1 Attaching to the Printer

Follow the procedure below to attach the belt clip to the printer.
1. Make sure that you are attaching the belt clip in the right orientation, then screw the screw that
comes with the belt clip into the designated screw hole to attach the belt clip to the printer.
2. Use the driver to firmly screw in the screw.

2.4.2 Using the Belt Clip

When the printer is attached to your belt, you can use it like the picture below.
Hold the printer firmly with your hand when you swipe a magnetic stripe card or cut paper.
If it is not held firmly, you may fail to read card data or cannot cut paper smoothly with the tear bar.
- 11 -