Setup; Battery Pack; Inserting Into The Printer Or The Battery Holder - Star SM-S230I SERIES Hardware Manual

2. Setup

2.1 Battery Pack

2.1.1 Inserting into the Printer or the Battery Holder

1. Make sure that the printer has been turned off before you insert or remove the battery pack.
2. Insert the battery pack into the back of the printer as in the figure shown below, following the
direction of the arrow.
3. To remove the battery back, pull back the hook, and use the opposite procedure from the one you
used to insert the battery pack.
4. The battery pack install into the battery holder. Insert the battery pack in the direction of the arrow.
Hook
- 4 -
Push the battery pack until the
hook clicks into place.