Sony DAV-IS50 Operating Instructions Manual page 22

Note
• During the "DMPORT" function, video signal is not output from the HDMI OUT and COMPONENT VIDEO OUT
jacks.
• The system can accept both digital and analog signals. Digital signals have priority over analog signals. If the digital
signal ceases, the analog signal will be processed after 2 seconds.
• When connecting the HDMI cable, make sure that the direction of jacks are the same.
• When connecting the digital optical cord, insert the connector until it clicks into place.
Tip
• You can connect another component, such as a VCR, digital satellite receiver, or PlayStation, to the TV (AUDIO
IN) jacks (A) or TV (DIGITAL IN OPTICAL) jack (B) instead of the TV.
To change the color system (PAL or NTSC)
(Asian, Oceanian and Middle Eastern models only)
Depending on the TV to be connected, you may be required to select either PAL or NTSC for the color
system.
The initial setting of the system for Oceanian and Middle Eastern models is PAL.
The initial setting of the system for Asian models is NTSC.
1
Press FUNCTION repeatedly until "DVD" appears in the front panel display.
2
Press SYSTEM MENU.
3
Press X/x repeatedly until "COLOR SYS" appears in the front panel display, then press
or c.
4
Press X/x to select a setting.
"PAL" or "NTSC" appears in the front panel display.
5
Press
.
The setting is made.
"NTSC" lights up in the front panel display when the color system is set to NTSC.
Note
• When you change the color system while the sleep timer function is activated, the sleep timer function is canceled.
Tip
• If the screen display of the TV disappears, go back to step 2 to change the setting.
22
GB