D.C.A.C. (Digital Cinema Auto Calibration) can
set the appropriate surround sound
• The system outputs a loud test sound when [AUTO
CALIBRATION] starts. You cannot turn the volume
down. Give consideration to children and neighbours.
• Make sure that the headphones are not connected to
the surround amplifier (not supplied). You cannot
operate the following steps with the headphones
Press FUNCTION repeatedly until
"DVD" appears in the front panel
DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
Press X/x to select
The options for [SETUP] appear.
Press X/x to select [CUSTOM], then
The Setup Display appears.
Press X/x to select [AUDIO SETUP],
The options for [AUDIO SETUP] appear.
Press X/x to select [AUTO
CALIBRATION], then press
The options for [AUTO CALIBRATION]
Connect the calibration microphone
(supplied) to the ECM-AC2 jack on the
rear of the control unit.
Set up the calibration microphone at the ear
level using the tripod, etc. (not supplied).
The front of each speaker should face the
calibration microphone, and there should be
no obstruction between the speakers and the
• The ECM-AC2 jack is used for the supplied
calibration microphone only. Do not connect
Rear of the control unit
To ECM-AC2 jack
Press C/c to select [YES].
[AUTO CALIBRATION] starts.
Be quiet during the measurement.