Installing the Memory
1.
Align the notch on the memory-card with the tab on the system-board connector.
2.
Press down on the memory module until the release tabs spring back to secure it in place.
3.
Install the drive cage.
4.
Install the front bezel.
5.
Install the cover.
6.
Follow the procedures in
Removing the Coin-Cell Battery
1.
Follow the procedures in
2.
Remove:
a) cover
b) front bezel
c) drive cage
d) heat sink
3.
Carefully press the release latch away from the battery. The battery will pop out from the socket, lift it out of the
computer.
Installing the Coin-Cell Battery
1.
Place the coin-cell battery into its slot on the system board.
2.
Press the coin-cell battery downward until the release latch springs back into place and secures it.
3.
Install the heat sink.
4.
Install the drive cage.
After Working Inside Your Computer .
Before Working Inside Your Computer .
15