Dell OptiPlex 9010 Owner's Manual page 50

Error Message
Plug and play configuration error
Read fault
Requested sector not found
Reset failed
Sector not found
Seek error
Shutdown failure
Time-of-day clock stopped
Time-of-day not set-please run the
System Setup program
Timer chip counter 2 failed
Unexpected interrupt in protected
mode
WARNING: Dell's Disk Monitoring
System has detected that drive [0/1] on
the [primary/secondary] EIDE
controller is operating outside of
normal specifications. It is advisable to
immediately back up your data and
replace your hard drive by calling your
support desk or Dell.
Write fault
Write fault on selected drive
50
Description
The computer encountered a problem while trying to configure one or more
cards.
The operating system cannot read from the floppy or hard drive, the computer
could not find a particular sector on the disk, or the requested sector is
defective.
The operating system cannot read from the floppy or hard drive, the computer
could not find a particular sector on the disk, or the requested sector is
defective.
The disk re-set operation failed.
The operating system cannot locate a sector on the floppy or hard drive.
The operating system cannot find a specific track on the floppy disk or hard
drive.
A chip on the system board might be malfunctioning.
The battery might be dead.
The time or date stored in System Setup does not match the computer clock.
A chip on the system board may be malfunctioning.
The keyboard controller may be malfunctioning or a memory module may be
loose.
During initial startup, the drive detected possible error conditions. When your
computer finishes booting, immediately back up your data and replace your
hard drive (for installation procedures, see "Adding and Removing Parts" for
your computer type). If no replacement drive is immediately available and the
drive is not the only bootable drive, enter System Setup and change the
appropriate drive setting to None. Then remove the drive from the computer.
The operating system cannot write to the floppy or hard drive.
The operating system cannot write to the floppy or hard drive.