Cooling/Heating/Fan Only Operation; Dry Operation - Toshiba RAS-M10GDCV-E Owner's Manual

COOLING/HEATING/FAN ONLY OPERATION

Start
a START/STOP button
Push this button to start the air conditioner.
b Mode select button (MODE)
Select Cool , Heat
c Temperature button
Set the desired temperature.
When the air conditioner is in FAN ONLY operation, the temperature display is not
indicated.
d Fan speed button (FAN)
Select one of "AUTO", LOW
• The OPERATION lamp (green) on the switch panel of the indoor unit goes on. And
operation starts after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start immediately.)
• The : Fan only mode does not control temperature.
Therefore, perform only steps a, b and d to select this mode.
Stop
START/STOP button
Push this button again to stop the air conditioner.

DRY OPERATION

Start
a START/STOP button
Push this button to start the air conditioner.
b Mode select button (MODE)
Select DRY
c Temperature button
Set the desired temperature.
• The fan speed display indicates AUTO.
• The OPERATION lamp (green) on the switch panel of the indoor unit lights, and
operation starts after approximately 3 minutes.
Stop
START/STOP button
Push this button again to stop the air conditioner.
, or Fan only . (For cooling only model)
+
, LOW , MED
+
, MED , HIGH .
11 EN