Table of Contents
Advertisement
Under Full Screen View or Quadrant View , click Input 1 , Input 2 ,
3
Input 3
, or Input 4 to display an input source in full screen view, or select
an input source in quadrant view on your HDMI output display device. For
information on full screen view and quadrant view, see
display"
on page 12.
Alternatively, you can select an input source in full screen or quadrant view
using keyboard shortcuts (see
shortcuts"
on page 20) or the Matrox MicroQuad buttons (see
Matrox MicroQuad buttons"
Remarks
If the resolution and frame rate on all SDI input sources do not match,
$
only SDI input channel 1 (SDI 1) will be displayed while the other
channels will appear black.
Switching between quadrant view and full screen view, or switching from
$
one input source to another is done without signal interruption.
Under HDMI Labels , you can customize the labels that appear on the HDMI
4
display device. Enter or select the HDMI label that you would like for each
input in the Label input 1 , Label input 2 , Label input 3 , and/or Label
input 4
boxes. The Matrox MicroQuad Remote Control Panel will retain the
last five HDMI labels that were entered so that you can re-use your most
common labels.
Remarks
The HDMI labels are limited to ten characters.
$
If you disconnect the USB cable from the Matrox MicroQuad unit, the
$
unit will display the current HDMI labels.
Under VU Meter and Output Audio Channel Selection , select the audio
5
input channels that you would like to monitor on the VU meters and output
to the HDMI display device. If you select 1-2 , 3-4 , 5-6 , or 7-8 , the selected
audio input pair will be displayed on the VU meters and output to the HDMI
display device. If you select 1 to 8 , audio input channels 1 to 8 will be
output to the HDMI display device and only audio input pair 1-2 will be
displayed on the VU meters. For more information about monitoring audio
levels, see
"Monitoring audio levels"
¦ Note If you do not indicate which audio pairs to output, audio input
channels 1 to 8 will be output by default and audio input pair 1-2 will be
displayed on the VU meters.
"Using the Matrox MicroQuad keyboard
on page 14).
on page 13.
Using the Matrox MicroQuad Remote Control Panel
"HDMI output
"Using the
19
Advertisement
Table of Contents
