Matrox Microquad's Synchronized Inputs; Hdmi Output Display; Quadrant View And Full Screen View; Selecting The Audio Channel Pairs To Output - Matrox MicroQuad User Manual

12

Matrox MicroQuad's synchronized inputs

Matrox MicroQuad synchronizes the video and audio on the HDMI output to
SDI input channel 1 (SDI 1). This ensures that when the HDMI display is in
quadrant view, all four video outputs are synchronized, thereby eliminating
artifacts and video tearing.
¦ Note If nothing is connected to SDI input channel 1 (SDI 1), then Matrox
MicroQuad automatically synchronizes the HDMI output to the next available
valid SDI input channel.

HDMI output display

Matrox MicroQuad outputs the video and audio from the SDI inputs to an HDMI
display device. The video output can be displayed either in quadrant view or in
full screen view, and you can select the audio channel pairs to be output.

Quadrant view and full screen view

Matrox MicroQuad allows you to monitor up to four SDI input sources at the
same time in quadrant view (see figure
page 11), or view a selected SDI input source in full screen view on the HDMI
display device (see figure
The quadrant view is the default view when you first supply power to Matrox
MicroQuad. A red selection box can be used in quadrant view to indicate which
video input will be viewed in full screen view when selected. You can show or
hide the red selection box using the DIP switch settings on the Matrox
MicroQuad unit (see
or the Matrox MicroQuad Remote Control Panel (see
MicroQuad Remote Control Panel"
To switch from quadrant view to full screen view, to move from one input source
to the next, or to select a video input to view in full screen, see
MicroQuad buttons"
Control Panel"

Selecting the audio channel pairs to output

Matrox MicroQuad allows you to select up to four audio channel pairs (from
audio channels 1 to 8) to output to the HDMI display device. To do this, you must
use the Matrox MicroQuad Remote Control Panel (see
MicroQuad Remote Control Panel"
audio pairs to output, audio channels 1 to 8 will be output by default. Audio is
output for the currently selected input source, or you can lock the audio output to
input channel 1 (SDI 1) using the DIP switches (see
MicroQuad DIP switches"
Chapter 3, Using Your Matrox MicroQuad
"Matrox MicroQuad full screen view"
"Setting the Matrox MicroQuad DIP switches"
on page 17).
on page 14 or "Using the Matrox MicroQuad Remote
on page 17.
on page 17). If you do not indicate which
on page 15) or using the Matrox MicroQuad Remote
"Matrox MicroQuad quadrant view"
"Using the Matrox
"Using the Matrox
"Setting the Matrox
on
on page 11).
on page 15)
"Using the Matrox