Using The Matrox Microquad Buttons - Matrox MicroQuad User Manual

14

Using the Matrox MicroQuad buttons

The Matrox MicroQuad buttons are used to switch from quadrant view to full
screen view and to cycle through the input sources on the HDMI display of
Matrox MicroQuad.
•
source to the next when in quadrant view, or to cycle through the different
video inputs when in full screen view.
•
screen view when in quadrant view, or to toggle between full screen view
and quadrant view.
Instead of using the Matrox MicroQuad buttons, you can use the Matrox
MicroQuad Remote Control Panel to switch from quadrant view to full screen
view and to cycle through the input sources on the HDMI display (see
Matrox MicroQuad Remote Control Panel"
Remarks
• You can lock the Matrox MicroQuad buttons by setting DIP switch 1
accordingly on the Matrox MicroQuad unit (see
MicroQuad DIP switches"
• If the resolution and frame rate on all SDI input sources do not match, only
SDI input channel 1 (SDI 1) will be displayed while the other channels will
appear black.
• Switching between quadrant view and full screen view, or switching from
one input source to another is done without signal interruption.
• If you want to select the audio channels for the VU meters and HDMI
output, you must use the Matrox MicroQuad Remote Control Panel (see
"Using the Matrox MicroQuad Remote Control Panel"
Chapter 3, Using Your Matrox MicroQuad
+ +
and (Cycle buttons) Use these buttons to move from one input
(Select button) Use this button to select the video input to view in full
on page 17).
on page 15).
"Using the
"Setting the Matrox
on page 17).